This is what our entryway seemed like earlier than the makeover. It was the very first thing company would see once they entered our dwelling.
And now, with the up to date fake brick, it units a heat and welcoming tone for the remainder of the house.
Step 1: Measure Your Wall
To get began, the very first thing you need to do is measure the size of your wall and decide the variety of brick boards you will want. They are available in Four ft x eight ft panels.
Step 2: Cut Down Your Panels
Once you know the way many panels you’ll want, determine the place you will want to chop your boards to suit in your wall. You can use a desk noticed or a round noticed to chop down your boards. We used one full panel. Three different items have been lower from a second panel to suit the whole space of our wall.
Don’t neglect about your retailers, too. You’ll want a jigsaw or hand noticed to chop out a small space within the brick panel to accommodate in your retailers.
Step 3: Nail Your Panels to the Wall
Locate the studs in your wall with a stud finder and utilizing your brad nailer, connect the panels into the studs first. I like to recommend nailing into the recessed “mortar” traces so when it’s time to smear your joint compound on, the nail holes shall be hidden.
Now, tape off any adjoining partitions and ensure your boards are good & safe to the wall, particularly the place two boards butt up subsequent to one another. You need it to be as flush as doable to cover the seam.
Step 4: Smear on the Joint Compound
Using a big putty knife or a hand trowel, scoop out some joint compound onto your software and start smearing it on to the brick panel. Apply from left to proper, up and down, working it into the entire nooks and crannies, one small part at a time. This is similar to the German Schmear course of, however as a substitute of moist mortar, we’re utilizing the joint compound to attain the same look.
While it’s nonetheless moist, take a step see the way it appears to be like on occasion. If you need extra brick to indicate by, simply return over with a clear putty knife. Apply stress to mild scrape away the surplus joint compound. You can even use a moist material to show extra of the pink brick space. This is the enjoyable half – simply taking part in round till you get the look you’re going for.
Step 5: Let the Joint Compound Dry
You could discover that the colour will change barely and the wall turns into extra white and opaque because it dried. If the protection is heavier than you need, you possibly can nonetheless use a moist material to take away the joint compound. Even after it has dried.
Step 6: Seal Your New Wall
Seal your newly whitewashed fake brick wall. If you could have it precisely the best way you need it to look, you possibly can seal it with a transparent matte polycrylic. I purposely left a whole lot of pink brick areas uncovered as a result of I knew I’d be sealing with a whitewash combination of water and paint. This would lighten it up a bit.
And that’s it! Step again and admire your new fake whitewashed brick wall that solely took a couple of hours to do. But appears to be like as if it’s been there for years!
The submit DIY Faux Whitewashed Brick Accent Wall appeared first on The Home Depot Blog.
Original supply: https://blog.homedepot.com/diy-faux-whitewashed-brick-accent-wall/